钻进"打滑层"钻头的设计要点

钻进"打滑层"钻头的设计要点

文章导航 > 钻探工程 > 2003 > (3): 23-23

温姝静. 钻进'打滑层'钻头的设计要点[J]. 钻探工程, 2003, (3): 23-23. doi: 10.3969/j.issn.1672-7428.2003.03.020

引用本文:

温姝静. 钻进"打滑层"钻头的设计要点[J]. 钻探工程, 2003, (3): 23-23. doi: 10.3969/j.issn.1672-7428.2003.03.020

Essential Points for Designing Bits Used in 'Slip' Formation[J]. DRILLING ENGINEERING, 2003, (3): 23-23. doi: 10.3969/j.issn.1672-7428.2003.03.020

Citation:

Essential Points for Designing Bits Used in "Slip" Formation[J]. DRILLING ENGINEERING, 2003, (3): 23-23. doi: 10.3969/j.issn.1672-7428.2003.03.020

详细信息

刊出日期: 2003-03-01

Essential Points for Designing Bits Used in "Slip" Formation

Publish Date: 01 March 2003

摘要: 我所针对钻探施工常遇到的"打滑层"的特点,合理设计钻头参数,制作了多种规格的"打滑层"钻头,钻进效果较好,为用户解决了钻进难题.笔者在实际工作中总结出以下"打滑层"钻头设计要点.

/