原地宇宙成因核素暴露测年方法中石英的提取

张丽; 武振坤; 宋少华; 常宏; 赵国庆

原地宇宙成因核素暴露测年方法中石英的提取

1.
中国科学院地球环境研究所黄土与第四纪地质国家重点实验室, 陕西西安 710075

2.
西安加速器质谱中心, 陕西西安 710061

3.
中国科学院研究生院, 北京 100049

4.
中国科学院地球环境研究所黄土与第四纪地质国家重点实验室, 陕西西安 710075

5.
西安加速器质谱中心, 陕西西安 710061

6.
中国科学院地球环境研究所黄土与第四纪地质国家重点实验室, 陕西西安 710075

7.
中国科学院地球环境研究所黄土与第四纪地质国家重点实验室, 陕西西安 710075

8.
中国科学院地球环境研究所黄土与第四纪地质国家重点实验室, 陕西西安 710075

9.
西安加速器质谱中心, 陕西西安 710061

基金项目:
国家重点基础研究发展计划(973计划)项目(2010CB833400)

国家自然科学基金项目(41023006)

收稿日期: 2012-04-26

刊出日期: 2012-10-28

Extraction and Purification of Quartz for in situ Cosmogenic Nuclide Exposure Dating

1.
State Key Laboratory of Loess and Quaternary Geology, Institute of Earth Environment, Chinese Academy of Sciences, Xi'an 710075, China

2.
Xi'an Accelerator Mass Spectrometry Center, Xi'an 710061, China

3.
Graduate University of Chinese Academy of Sciences, Beijing 100049, China

4.
State Key Laboratory of Loess and Quaternary Geology, Institute of Earth Environment, Chinese Academy of Sciences, Xi'an 710075, China

5.
Xi'an Accelerator Mass Spectrometry Center, Xi'an 710061, China

6.
State Key Laboratory of Loess and Quaternary Geology, Institute of Earth Environment, Chinese Academy of Sciences, Xi'an 710075, China

7.
State Key Laboratory of Loess and Quaternary Geology, Institute of Earth Environment, Chinese Academy of Sciences, Xi'an 710075, China

8.
State Key Laboratory of Loess and Quaternary Geology, Institute of Earth Environment, Chinese Academy of Sciences, Xi'an 710075, China

9.
Xi'an Accelerator Mass Spectrometry Center, Xi'an 710061, China

Received Date: 26 April 2012

Publish Date: 28 October 2012

摘要

摘要: 原地宇宙成因核素10Be和26Al的暴露年龄测定是近年来发展较快的测年技术,已在地学研究中得到广泛应用。该方法需要选用经一系列前处理过程获得的纯净石英作为待测样品,制备成BeO和Al2O3以供加速器质谱仪测量。因此获得高纯度的石英样品,是该测年方法的关键环节之一。本研究在已有报道的石英提纯化学流程的基础上,尝试对流程进行部分优化,通过实验对比不同粒径组分、不同固液比水浴振荡器和滚筒HF-HNO3蚀刻效果,确定使用HF-HNO3(1%或2%,固液比15.0 g/L)滚筒加热法刻蚀样品以去除铝硅酸盐,多钨酸钠重液分离样品中的石英和其他组分。优化的分离纯化流程应用于处理采自祁连山北缘河流阶地含石英的岩石样品,经纯化的石英纯度可达98%以上,Al的含量小于200 μg/g,表明采用优化的提取流程获得了高纯度的石英样品,可以满足10Be和26Al暴露测年所需样品要求。
- 原地宇宙成因核素 /
- ¹⁰Be /
- ²⁶Al /
- 石英 /
- 提取纯化
Abstract: 10Be and 26Al in situ cosmogenic nuclide exposure dating is a relatively new dating technique, which is widely used in geoscience research. Normally, the BeO and Al2O3 measured by AMS are prepared from purified quartz samples. Therefore, it is key to develop a method to extract pure quartz from rock sampled in fieldwork. Based on the experimental procedure of Kohl and Nishiizumi, a comparison was made for the different etching effects on samples by using heated water bath oscillator and hot-dog machine (roller) with different grain size of 0.25-0.50 mm and 0.50-1.0 mm. The 1% or 2% HF-HNO3 were applied to dissolve the silicates in the hot-dog roller machine with a solid/liquid ratio of 15. Detailed heavy liquid (sodium polytungstate) separation steps for quartz purification are also described in this paper. The pretreatment method was verified by using quartz from the river area around North Qilian Mountain. The results indicate that SiO2 content in the purified quartz is greater than 98% and the Al content is less than 200 μg/g, by using X-ray Difrraction (XRD) and Inductively Coupled Plasma-Atomic Emission Spectrometry (ICP-AES). The high purity quartz was obtained by the established pretreatment method which met the requirements for 10Be and 26Al exposure dating.
- in-situ /
- cosmogenic /
- nuclides /
- ¹⁰Be /
- ²⁶Al

HTML全文

施引文献

资源附件(0)

访问统计

计量

文章访问数: 1460
PDF下载数: 5
施引文献: 0

原地宇宙成因核素暴露测年方法中石英的提取

Extraction and Purification of Quartz for in situ Cosmogenic Nuclide Exposure Dating

计量

出版历程

目录